How to make your own ZAPPER

In our Previous articles , we mentioned the benefits of the Zapper. There are many kinds of zappers. Each have their own benefits as well as there downside. They work based on different understanding on how zapper will cure people.

Have you ever tried a zapper?

For example:
– Hulda Clark follower will use square wave with positive offset
– Royal Rife follower will use sine wave with very precise frequency control
– Bob Beck follower will use square wave with -33V to +33V output (bipolar output).
– Personally I use Andrija Puharich influence, to use a spiked output.

Hulda Clark Zapper
The design of zapper is included in Dr. Hulda Clark book The Cure For All Diseases. It is like this:

Dr. Hulda Clark mentioned that the frequency (of the Zapper) does not matter, but it must have  a positive offset and must be battery operated. She also mention spesific kind of use, mainly be repeating zapping after 15 to 30 minutes of rest three times, 3 to 7 minutes for each zapping, for example:
5 minutes zap – 15 minutes of rest – 5 minutes zap – 15 minutes of rest – 5 minutes zap

Many have improved Dr. Hulda Clark’s original design by incorporating a “special frequency”. There are those who Earth’s  frequency of 7.5Hz, 8Hz or 15Hz. There are those who use digital signal like what used by Royal Rife’s student John Crane, who use spesific audio frequency for different kind of disease.

However, implentation with special frequency may not be as effective for cheap device since many cheap zapper implementations use cheap timer chip. Because of cheap timer chip characteristic, the frequency will never be accurate since the frequency will drop when the battery begins to loose power. Electronic component also may allow one implementation to the other to differ in frequency for more than 5% in the actual implementation. Some solve this by using an adaptor, using the power from the wall. This may produce another problem, because some people believe that wall electricity have many bad frequency interference than can reduce health.

Some other variations include a better ‘square wave’ shape when the device is in use, the square wave normally would be softened. That is done by adding a resistor and capacitor at the output. The circuit illustrated below also uses a higher duty cycle (longer ON than off), which said to improve the number of possible harmonic frequency.
Zapper Design

Robert “Bob” Beck Blood Electrifier
Dr. Robert Beck  has a  different requirement for his Zapper. The output voltage must have an inversing polarity during cycle and with voltage output between 27V to 33V. Most applications use three 9V battery to produce output voltage of -27V and +27V.

The diagram below is provided by Zapper Technologies,  which unfortunately now has a broken link.

Beck’s original design:

Beck’s modified design:

Zapper Technologies modification:

This link below has a good step by step and clear diagram, especially if you are unfamiliar with electronics:
I’ve built my own single 9V dc Beck’s blood cleaner

My Zapper
It has been my experience that voltage spikes can produce better results than square wave. We can obtain  voltage spike by suddenly turning off the  current that flows in a coil. The coil will then react by producing very high voltage.

The basic:

The power of this zapping  method is proportional to the source voltage and the inverse of the coil resistance. Using a  1.5 volt battery and coil with 1 ohm resistance, you may not feel anything, but the same coil with 12V power source will produce very  sharp or painfull zap.

To allow repeated spike, you need something that switch on and off continuously. You can use relay, but you may need to add a  resistor or capacitor in the output to reduce the level of shock.:

My personal zapper is this one:

I call it stingo zapper. The coil use ferrite toroid core. The variable resistor will allow you to change the power level and the frequency. To limit the output power to increase safety, it use two 1.5V battery as power source. At minimum power it can make people sleepy, at high power level you can feel painfull zapping. You don’t need to use painfull power level, you will see results even if you set this at pain less setting.

Suggestion from Stephan Carter:
Let the stingo zapper run itself without touching anything for a few minutes before using it to other people to prevent bad energy transfer.

The photo below illustrate the correct way to connect the transistor, click for bigger picture:

Here are the complete parts for my latest implementation:

The results:

Steady voltage version
Prevous article mention how ancient people use marine torpedo to cure headache. People had been repeatedly use electricity to cure themself. At 1930’s people used a  steady voltage to maintain their health. Here is a modern adaptation of it. It  requires a 12V battery, this is actually a  method to clean body before handling Joe Cell, a free energy device :
This process is similar to showering, bathing or sleeping – only in that it is not permanent! Therefore as often as you need to work on your Joe Cell to get it beyond Stage 1, you may need to follow this process. There is the  minimal equipment required:

1    compass or analogue watch/clock
1    12V battery, fully charged with clean terminals

 1   chair (non magnetic)
 1  four sided table (non magnetic)

Make sure  that your hands are clean. The steps for this simple process are:
Step 1  Use the compass or watch to determine the direction of North.
Step 2  Align the sides of the table to each of the cardinal compass directions.
Step 3  Place the chair on the North side of the table so that when you are sitting in it you are looking South over the table.
Step 4  Place the battery on the table with the + (positive) terminal to the West and the – (negative) terminal to the East.
Step 5  Sit in the chair facing the table.
Step 6  Lick your Thumb, Index and Middle fingers of your right hand.
Step 7  With your right hand reach across your body and using the digits moistened with your saliva grip the – (negative) terminal.
Step 8  Keep your left arm in your lap or by your left side and wait in that position for 30 seconds.
Step 9  Lick your Thumb, Index and Middle fingers of your left hand.
Step 10 With your left hand reach across your body under your right arm without touching it or your clothes and using the digits    moistened with your saliva grip the + (positive) terminal.
Step 11  If you feel any “buzzing” in your fingers or thumbs, then with one digit at a time, break contact with the terminal (ie lift it off but leave the rest in contact) and circle/move/rotate it in an anticlockwise direction seven times, then put it back on the terminal. Repeat this process as many times as necessary for each digit until you feel no “buzzing”.
Step 12  Once all “buzzing” has been eliminated then maintain your grip for at least five minutes but no more than seven minutes. Ensure that you keep an air gap between your arms during the whole time.
Step 13  Release your grip of the + (positive) terminal and move your left hand back across your body under your right armt without touching it or your clothes to the position it was in at Step 8.
Step 14  Release your grip of the – (negative) terminal and move your right hand back across your body.

You should now be temporally “polarized” in a form that is “good for getting the cells.

Try it and write us with your results!

 Caution and Disclosure

Please proceed with care. While many people have already testify positive results, never underestimate the power of the Zapper. Always start with a  limited time of use per day, 5 minutes a day for example. Then steadily increase up to 30 minutes a day.  If you don’t notice progress in a month, then it may not be effective for you. Please feel free to contact me with any questions or concerns.

Written and reported by Sucahyo

The Truth Denied Team

Staff Writter

If you have questions regarding this article, please contact Sucahyo at info@thetruthdenied.com  subject line ZAPPER

Please follow and like us:

18849

7586339647

988k

72349